LITHONIA LIGHTING PS3000 M3 Emergency FLUOR Ballast,Power Sentry,86W

Description

LITHONIA LIGHTING PS3000 M3 Emergency FLUOR Ballast,Power Sentry,86W. Only opened to take a picture.
Emergency fluorescent battery pack
FEATURES & SPECIFICATIONSINTENDED USE — Designed for applications requiring full light output. Field installed with fluorescent fixtureto operate lamp(s), based on one 32W T8 linear lamp. The light output for other lamps will vary, providingoptimum glare-free illumination for a minimum of 90 minutes upon interruption of normal power.CONSTRUCTION — 20-gauge, black steel housing.Dual-voltage input capability (120V or 277V).PERFORMANCE — Compatible with electronic, rapid-start, instant-start, slimline, preheat or trigger startballasts in standard or energy-saving configurations for 90 minutes emergency operation. See page 2 forcompatibility table.Protects against partial or isolated power outages. Low-glare, shadow-free illumination provides excellentvisibility for safe building evacuation. Unit wires two ways: on night-light circuit (permanently energized) oron switchable circuit (unswitched circuit to battery pack and switched circuit to the fixture ballast). Unit willstrike "normally off" lamp.ELECTRICAL — Constant current series resistor-type charger, provides high efficiency and reliable operation.High-efficiency push-pull inverter is the most effective method of converting DC power to AC power. It providesmaximum light output, battery life and reliability.AC/LVD reset allows battery connection before AC power is applied and prevents battery damage from deepdischarge.BATTERY — Sealed, maintenance-free, high-temperature nickel cadmium battery. Ensures long life over widetemperature ranges. Battery automatically recharges after a 90-minute discharge.External battery connectors allow battery pack to be disabled for maintenance and installation.Pilot light and test switch provide visual and manual means of monitoring system operation. Two 1/2" holesare required to permit mounting of pilot light/test switch in fixture housing.INSTALLATION — Mounts concealed within the plenum or on top of fixture housing for improved aestheticsand protection from vandalism. Wiring protected by 18" flexible conduit. Remote mounting requires accessory kit ELA PSDMT.Emergency Ballast may be remote mounted up to 50 feet from fixture or half the distance recommended bythe AC ballast manufacturer, whichever is less.Test switch may be remote mounted up to eight feet from fixture. For additional feet refer to the accessoriesfor ordering.LISTING — UL listed. Meets UL 924, NFPA 101 (current Life Safety Code), NEC and OSHA illumination standards.